Kenneth D. Westfall on wed 8 oct 97
Sandy,
In response to the smoothing question...it is not easy to smooth the surface
of a bisqued pots, especially one of that size. Depending on how rough it
is, you may be able to get some silicone carbide sanding paper and knock off
any small rough spots. I don't think grinding is a good option. It's
pretty important to do this finishing step BEFORE bisquing.
In response to the glazing... spraying the glaze or pouring the glaze on are
the two options I would use. To spray, you'll need compressed air and a
sprayer. A containment area is good and you should wear a respirator. Alot
depends on the glazes you're working with, too. Consider health issues.
To pour the glaze on, you'll first need to line the inside of the pot with
glaze and let it dry. Then, locate a large tub (like a galvanized or
plastic wash tub) and place in on a level spot on the floor. Choose a spot
where you can hose the area down when you're done. Place your banding wheel
in the center of the tub and put the pot on it. Get your glaze ready...and
a large cup...now center the pot and get it spinning... using the cup, pour
glaze on the spinning pot (be careful, it will splash!!!!!!) until you feel
you have the right amount of glaze. You may have to spin the banding wheel
a couple of times. Wait til dry, then remove pot and clean bottom before
firing. It's simple, eh?
Good luck, and it takes practice...
Tracey Westfall
Pine Hill Pottery
pinehill@ruralnet.org
Kenneth D. Westfall
Pine Hill Pottery
RD#2 Box 6AA
Harrisville, WV 26362
pinehill@ruralnet.com
DON'T GET STUCK IN THE MUDPIES--K & T
| |
|
