Bill Buckner on thu 17 apr 97
I have been offline for some time now, and therefore out of touch with the
conversation. Please forgive me if I repeat past topics here.
I am planning to get a soda kiln under construction this summer. The
design is fairly small (~16 cu. ft. setting area). The plans involve a HB
floor, firebox, and bag wall, and coated IFB walls. This is intentionally
an experimental kiln. I am prepared to take risks with it.
I would appreciate any discussion from folks with experience using IFB in
soda kilns. Use your own discretion in posting me back through ClayArt,
or directly to my address.
Thanks,
-Bill
Bill Buckner e-mail: bbuckner@gsu.edu
Georgia State University http://www.gsu.edu/~couwbb
| |
|
